HVAC Company in Pueblo, CO

Regular service maintenance on 2018 American standard equipment. 80% upflow equipment installed in basement. Spoke with client upon arrival to go over expectations and time. Set system to heat for testing. Equipment heating 42° above set temperature throughout home. verified all safeties insecurities connected to circuit board before beginning service. Inducer motor, gas valve, and blower motor tested within manufacturer tolerances. Static pressure tested normal at .42WC/.5 0WC rated. Heavy dirt buildup on filter cleaned and replaced. Wiped down all equipment top to bottom. Updated client on all findings. Recommendations include proactive indoor air quality attachments. Client will follow up on any future work requested. System successfully cycled before departure.

Full System Replacement (High Efficiency) Work Completion Dates: 10/29/2026 Install, will return in 2 weeks or so to install heat strips (they are on back order) 11/06/2026 - Duct Cleaning (need to confirm with Lu this date works) Payment Type: Greensky Special Notes: NONE Duct cleaning service completed for the HVAC system. The service included cleaning 11 supply vents and 1 return vent. Dust and debris were removed from the areas serviced to help support cleaner airflow through the system.

#manger Sent quotes for replacement furnace Only one in stock of the standard 80%. Then 80%er's are done in Colorado. Low-nox/high efficiency mandate is in full swing.

Furnace tune up. 6 months old. Left options for surge protection and IAQ

Furnace tuneup/maintenance 7 yr old carrier 80% furnace Started system from thermostat to ensure normal operation, systems started without an issue. Inducer motor was reading with manufacturer specifications. Gas valve was reading with the manufacturer specifications. Resurfaced the flame sensor, has buildup on it gave options to replace. Blower motor looks clean with no signs of oil leak. Squirrel cage looks clean with little dust buildup. Duct pressure was reading within manufacture specifications Delta was within manufacturer specifications. Everything working at this time. Paid visit $79 due, added a membership for $250. $329 due, paid with check

No heat call, thermostat not working Customer stated thermostat wasn’t working, found that thermostat was not turning on heating mode. Changed thermostat to a p200 Honeywell thermostat, system started everything working at this time. Paid in full with check

Came out for fan powered humidifier. I'm installing it tomorrow.

Service call to change clients filter/verify equipment clear for winter. Technician Levi was out for furnace service in March and clients wanted to double check before running system. Set system to heat for testing. Equipment heating 16° above set temperature. Inducer motor operating on higher 80% of amperage range. Gas valve and blower motor tested within manufacturer tolerances. System static pressure tested .22 WC/.50WC rated. Burner flames had slight yellow across bridge pointing to signs of oxygen mixing into heat exchanger. Upon further inspection equipment, giving off 3/5 PPM of carbon monoxide throughout the home. Updated clients on all findings and safety concerns on equipment. Verified equipment, not registered for extended warranty, covering heat exchanger. Due to age, safety, concerns, and compounding issues do not recommend repairing. Cannot provide replacement for heat exchanger due to age and safety. Provided client with proactive replacement on equipment. New system com

Completed the swamp cooler shutdown and inspected the unit, noting that the cardboard pads will need to be replaced. Additionally, checked the water level to address the homeowner's report of excessive drainage.

The 2007 Tempstar furnace is operating safely within manufacturer specifications after replacing the dirty filter, wiping down the assembly, and resurfacing the flame sensor, but it requires an upgrade to high efficiency due to an extremely worn heat exchanger. Job complete.