HVAC Company in Pueblo West, CO

Checked all components to furnace and checked order of operations on furnace and no issues were found. Customer had stated that thermostat was not shutting off when temp was met. Went ahead and replaced thermostat after testing previously installed one. New thermostat did in fact, shut off system when temp was met. No further issues found on HVAC system during furnace maintenance at this time.

Compressor is going into thermal overload. 2006 Goodman Equipment. Coil is freezing and leaking into furnace. Cools at first but then fails. Compressor runs when everything is shut off. Only stops running when disconnect is pulled. Time to update system. Quotes sent. Install available next Thursday.

Five month old ream, furnace and AC installed by Clarks. Spoke with clients upon arrival about expectations and time. First official test of season. Regular hot smell coming from heat exchanger from first heat. System heating efficiently 40° above set temperature. Systems static filter working properly, recommend changing three months. Cleaned burners, gas valve, circuit board, blower compartment. Light buildup of dust throughout system regular for crawlspace. UV bulb operating properly. Repaired insulation lining supply. System operating well within manufacture tolerances. System static pressures tested normal .35WC/should test .50WC. Static pressures relative to single stage heating. Recommendations include ongoing maintenance. System was cycled before departure.

>1 year old Rheem, furnace and AC installed by Clark’s. Spoke with client to go over expectations and time. Turn system on for testing with 30° temperature split above set temperature. Cleaned unit top to bottom. Cleaned burners and manifold, gas valve, circuit board, and blower compartment. Double checked all wiring and safeties to circuit board. Cleared condensation line, and inducer reservoir. System running in single stage reflected in pressures. Recommendations include 24 V filter for ongoing cleanliness, duct, cleaning, and ongoing maintenance. System is operating within healthy tolerances. Cycled before departure.

Came out today for ac swap. Recovered refrigerant. Removed and replaced old with new. Turned system on. Sub cool between 10 and 12, delta being right around 19° and customer has smoke and co, job complete. Good to go.

2022/24 Rheem furnace and condenser units. Recommendations include ongoing maintenance, and full system, duct, cleaning and sanitization. Duct cleaning allows, better static pressure, prolonged life of internals. Client will follow up on any future work requested. Both systems were cycled before departure.

Upon arrival, customer stated that refrigerant lines were froze up to evap coil. Customer had replaced filter. Customer also said that thermostat in bedroom would not shut off compressor. Customer will keep an eye on thermostat due to possible relay bad in thermostat. Checked evap coil on both sides to make sure there was no debris or blockage. Coil was also not frozen and circulating air properly. Checked blower cage for any debris blower cage does have debris but nothing concerning. Will suggest cleaning in spring time. Also took a Delta and Delta is within range. Condenser coil was clear and condenser fan motor was rejecting heat properly. Checked filter drier for restriction and was not restricted. Put gauges on system and found Schrader valve on the liquid line side valve was stuck open. Went ahead and replaced Schrader valve and added refrigerant for loss putting gauges on. Maintained proper pressuresand sub cool. No further issues were found on HVAC system. Boiler is working pro

One year-old Clark installation. First furnace tuneup above season. Tested heating and cooling upon arrival. System heating 30° above set temperature, cooling 20° below set temperature. Verified all safety connections to circuit board before testing tolerances on furnace. All system internals tested within manufacture specifications. Notated pool of yellow oil in return rack. Cleaned as best as possible after verifying source. No leaks detected from equipment or refrigerant on new system. Refrigerant levels tested 113/250 overall. 7° sub cool consistent. Verification of braces needed at connection point on coil.Follow up tentative. System was successfully tested, cleaned before departure.

Sent quotes for Furnace and AC Replacement quotes. Client was expecting 10k for furnace and AC. Will most likely call in the morning to book for next Monday.

AC service maintenance on 2006 American Standard furnace and condenser. System was cooling 22° below set temperature upon arrival. Clients concerns revolved around solid readings on system to monitor ongoing repair needs and or replacement. Double checked all safety connections, and wiring to circuit board on furnace. Notated heavy dust buildup on underside of a coil. Heavy dust and dirt buildup on blower and motor. Some oil on shaft of blower motor. Condenser unit operating under manufacture specifications. Refrigerant pressures irregular with low suction/86, liquid/250. Signs of restriction on a coil apparent due to pressures. blower motor camping six overall plus dirt buildup can be affecting pressures and efficiency adversely. Cleaned unit inside and out with coil cleaner and water before reassembly for final test. Unit is operating at approximate 50 to 60% efficiency. Low efficiency plus extended run time equals higher bills overtime.Client will update about any future work reques