Walsenburg, CO

Furnace maintenance- Checked air filter and removed filter. Customer will be replacing it. Cleaned flame sensor on furnace. Cleaned furnace inside and out. Checked for restrictions in pressure switch tubing and drains. Checked for CO and checked heat rise. Heat rise is in range and nonCO was detected. System ran full cycle and no errors were found. Furnace is good to go for upcoming season.

Furnace maintenance- cleaned flame sensor, checked for CO, checked for filter and customer has pad filter, cleaned unit and cleaned combustion box, checked blower cage and capacitor. Will need to keep an eye on blower due to debris on fins. Tightened electrical connections and tightened couplings on inducer motor, fresh air, and exhaust. Checked pressure switch tubing. No further issues at this time on furnace.

Furnace maintenance- cleaned flame sensor, checked for CO, checked for steady blue flame, checked heat rise and is in within spec, blew out system with co2, no issues found on furnace at this time.

Customer stated duct work had rodents invading supply and now possibly return. Found spot where rodents were getting into supply run. Other rooms had nests and mice droppings at supply opening. Pictures are attached with damages. Damaged run is 6 inch. Will replace runs and will replace ducts due to mess. To replace flexed runs we will need to cut open insulation to get to supply runs. We will not replace insulation covers we will only patch the damaged area and seal openings made by us. Customer will call office once a decision is made. Emailed estimates. Job complete.

Tech came to location for Service estimate on furnace. Natural draft furnace with asbestos supply and connection points. Dependent on code corrections, recommendations are either 80,000 BTU/80 K furnace, or 70,000 BTU/90% efficient furnace. Goodman manufacturing. Water heater must also be vented into chimney, or exerted outside. Not cycled before departure. Job complete.

This estimate is for replacement of condenser fan motor and a capacitor. Upon review of system I have found that the condenser fan motor has seized up and locked out. Motor has gone bad and needs to be replaced in order for central cooling system to operate properly. Will return to replace condenser fan motor. Job complete.

Replaced control board on system. Found burnt thermistor on board and burnt circuit on back of board. Once board was replaced system started up with no problems. Found dirty filters in return grills of home and removed them. Customer will replace them. No further work needed at this time.

Came out for ac install. Installed one Amana 3 ton condenser and coil. Removed and replaced old with new. System cooling with no issues. Job complete.

Onsite today for an AC Add-On Estimate. Went over options for a 3-ton AC. The client would like to proceed with the installation on Wednesday. Installation Scheduled.

Out today evaluating a 2003/2005 Temprite Furnace and AC for efficiency issues today. Furnace is in great condition with a good blower for its age, no need to replace. Will Install AC unit next week. Job complete.